Larson Electronics HAL-36-25W-LED-JB-1227-M Instruction Manual
    |
HAL-36-25W-LED-JB-1227-MLarson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 430W LED Fixture for Hazardous Location Lighting120-240V - C1D2 - 3900 Lumens - Magnet MountInstruction Manual• INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANYRELEVANT LOCAL BUILDING CODES.• RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICALSYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARPOBJECTS. SUITABLE FOR DAMP LOCATIONS.IMPORTANTREAD CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTUREREFERENCE. THE HAL-36-25W-LED-JB-1227-M MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICALCODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THISPRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET, CONSULTAN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE INSTALLATION ORPERFORMING ANY MAINTENANCE.RISK OF FIRE/ELECTRIC SHOCK – DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING. RISKOF PERSONAL INJURY – FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY. RISK OFBURN – ALLOW FIXTURE TO COOL BEFORE SERVICING.Thank you for your purchase of the Larson Electronics HAL-36-25W-LED-JB-1227-M.WARNING:READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.CRITICAL SAFETY INSTRUCTIONS:WARNING:USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. THIS LINECORD IS INTENDED TO ALLOW OPERATORS TO EXTEND POWER TO EQUIPMENT WHEN STATIONARY OUTLETS ARE NOTREADILY AVAILABLE.IMPROPER USE OF THIS CORD, PLUG, AND RECEPTACLE CAN LEAD TO SERIOUS INJURIES OR DEATH TOPERSONNEL.PERIODIC INSPECTION OF THE CORD IS NECESSARY.THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY ARE FOUND,THE CORD MUST BE REPLACED BEFORE RESUMING USE. |
Related manuals for Larson Electronics HAL-36-25W-LED-JB-1227-M
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine