LaserLiner MultiMeter XP Operating Instructions Manual

Contents

18Safety instructionsDealing with electromagnetic radiation• The measuring device complies with electromagnetic compatibility regulations and limits in accordancewith the EMC Directive 2014/30/EU which is covered by the Radio Equipment Directive 2014/53/EU.• Local operating restrictions - for example, in hospitals, aircraft, petrol stations or in the vicinity of peoplewith pacemakers - may apply. Electronic devices can potentially cause hazards or interference orbe subject to hazards or interference.Safety instructionsDealing with RF radiation• The measuring device is equipped with a wireless interface.• The measuring device complies with electromagnetic compatibility and wireless radiation regulationsand limits in accordance with the RED 2014/53/EU.• Umarex GmbH & Co. KG hereby declares that the MultiMeter XP radio equipment complies with theessential requirements and other provisions of the European Radio Equipment Directive 2014/53/EU (RED).The EU Declaration of Conformity can be found in its entirety at the following address:http://laserliner.com/info?an=mumexpTest prodsWith protective cap: CAT III up to max. 1000V / CAT IV up to max. 600VWithout protective cap: CAT II up to max. 1000VMeasuring contacts• The device works with LEDs of risk group RG 0 (exempt, no risk) in accordance with the latest versionsof applicable standards relating to photobiological safety (EN 62471:2008-09ff / IEC/TR 62471:2006-07ff).• Radiation power: Peak wavelength equals 456 nm. Mean radiance is below the limit valuesof risk group RG 0.• When used for the intended purpose and under reasonably foreseeable conditions, the accessibleradiation of the LEDs is safe for the human eye and skin.• Temporary, irritating optical effects (e.g. dazzling, flash blindness, afterimages, colour vision impairment)cannot be completely ruled out, especially under low ambient light conditions.• Do not intentionally look directly into the radiation source for longer periods of time.• No specific measures are required to ensure the limit values of risk group RG 0 are maintained.EN