Laserworld CS-250G Using Manual

Also see for CS-250G: Manual

Contents

Laserworld CS-250G Using Manual Manual pdf 4 page image

Manual / Bedienungsanleitung: CS-250 G, CS-400 GVersion Oct-104 / 10DMX controlchannel Function1 Mode: 0-69 laser off; 70--139 sound mode; 140-209 animatedsound mode (see above); 210-255 DMX mode2 Pattern3 Effect channel: Strobe4 Horizontal movement: 0 no effect; 1-167 (fixed) movement; 168-188 animated movement left to right with increasing speed; 189-209 dto. Right to left; 210-255 dto. left to right and back5 Vertical movement: analogous to hor. movem.6 Zoom: 0-10 no effect; 11-104 increasing size; 105-154 growingwith increasing speed; 155-204 dto. shrinking; 205-255 dto.growing/shrinking7 Width (rotation about y): 0-150 fixed rotation; 151-255 automaticrotation with incr. speed8 Height (rot. About X): analogous to width9 Rotation: 0-180 fixed rotation; 181-217 automatic with incr.speed clockwise; 218-255 do. counter clockwise10 Blanking: 0-70 no effect; 71-139 points are brighter; 140-209dashed lines; 210-255 points only11 WavePlease note that not all effect channels are available for all patterns. E.g. you can’t zoom dynamic patterns, etc.Channel 3 (strobe) is also available when in soundmode (channel 1 70-209).ILDA modeWhen an ILDA compatible interface is connected to the laser, the laser is automatically switched to ILDA mode.Output is then controlled by a PC running laser control software. The scanners are set for ca. 10000 PPS at 20-25° optical. When running faster, reduce image size/scan angle.Maintenance / cleaningAlways disconnect from the mains when the device is not in use or before cleaning it.Open the device by removing top cover, remove 4 screws, 2 upper on front and back panel each. Remove anydeposits of dust, especially at the fan. Check for condensed fog fluid inside. If so, clean and rearrange theposition of laser and or hazer. Mirrors need cleaning when a “halo” is noticeable around the beam or anunusual high amount of diffuse light can be seen inside the device. Clean the mirrors with window cleaner anda paper towel.Never look directly into the light source. Always disconnect from the mains when the device is notin use or before cleaning it.TroubleshootingProblem Possible causeNo function / fan not working Check mains connectionEffects don’t change to the beat of the music Adjust sensitivity with the dial on the back.Check if device isn’t in DMX or autom. modeProblems with DMX control Check DMX address selectionDevice not working, but fan working Turn device off for ca. 1 minute.Laser does not switch to ILDA mode:• The interface does not connect pins 4 and 17 (Interlock) of the IDLA signal. See interface manual• The cable does not connect pins 4 and 17. Use a cable that connects pins 4 and 17.• Use an adapter that connects pins 4 and 17.