Lasko 6405 Important Instructions & Operating Manual

Contents

Lasko 6405 Important Instructions & Operating Manual Manual pdf 2 page image

Rev. C 2/13 2 6405ES 7 6405ESRev. C 2/13FUNCIONAMIENTO (Figura 1)1. Cuidadosamente retire el Calefactor de la bolsa y de la caja.2. Coloque el Calefactor sobre una superficie firme y plana.Los tacos de plástico o hule, tales como las patas de esta unidad, pueden pegarse a la superficie de los muebles y/o a los pisos demadera. La unidad podría dejar un residuo capaz de oscurecer, manchar o dejar marcas permanentes en el acabado de ciertas superficiesde muebles, incluyendo superficies de madera y/o pisos de madera.3. Conecte el cable a un tomacorriente de 120 voltios.Asegúrese que el enchufe encaje firmemente en el tomacorriente.Cuando los enchufes quedan flojos dentro de los tomacorrientes, podrían deslizarse parcial o completamente fuera deltomacorriente con el menor movimiento del cable adosado. Los tomacorrientes en este estado podrían sobrecalentarse yrepresentar un peligro de incendio grave; si queda cubierto por una cortina o tela, el peligro de incendio es todavía mayor.4. Cuando el Calefactor se conecte por primera vez, se oirá un “bip” indicando que hay electricidad en la unidad.5. ENCIENDA el Calefactor oprimiendo el Botón de Encendido.6. Cuando se lo encienda por primera vez, el Calefactor estará en calor Alto (1500 vatios) en Máx. (La luz Alta estará encendidapermanentemente y la luz de Máximo estará titilando).7. Oprima el Botón de Encendido una vez más y el Calefactor estará en Calor Bajo, indicado por la luz permanente junto a Bajo. La luzde Máximo estará titilando.8. Oprimir el Botón de Encendido por tercera vez APAGARÁ el Calefactor.Función de OscilaciónPresionar el Botón de Oscilación (OSC) permitirá al Calefactor oscilar hacia atrás y hacia delante. Para detener la oscilación, oprimael Botón de Oscilación (OSC) una vez más.Función de TemperaturaPara ambientar la habitación a una temperatura específica, oprima el Botón de Temperatura hasta la posición deseada. La luz debajode la temperatura seleccionada continuará titilando hasta que la habitación alcance la temperatura deseada.Función de TemporizadorLa Función de Temporizador puede ser activada cuando la pantalla del Calefactor se encuentre en cualquier velocidad o temperatura.Esta función le permite a usted seleccionar la cantidad de tiempo que el Calefactor estará en funcionamiento antes de apagarseautomáticamente, de 1 hora a 7 horas. Oprimir el Botón de Temporizador aumentará la cantidad de tiempo, en combinaciones de1,2 y 4 horas. Oprimir el botón continuamente resultará en que el temporizador quede fijado para un lapso de 7 horas. El Calefactorse apagará cuando el tiempo fijado haya transcurrido. La unidad puede ser apagada oprimiendo el Botón de Encendido.MODELO 6405Figura 1Botón deEncendidoBotón deTemperaturaBotón deOscilaciónBotón deTemporizadorSAVE THESE INSTRUCTIONS• ALWAYS PLUG HEATERS DIRECTLY INTO A WALL OUTLET/RECEPTACLE. NEVER USE WITH AN EXTENSION CORD. DONOT PLUG HEATER INTO ANY OTHER CORD CONNECTED DEVICE, SUCH AS A POWER STRIP, SURGE PROTECTOR,MULTIPLE OUTLET ADAPTER, CORD REEL OR OUTLET-TYPE AIR FRESHENER. THE USE OF SUCH DEVICES MAY CREATEA FIRE HAZARD. PLUG UNIT DIRECTLY INTO A 120V WALL OUTLET ONLY.• FAULTY WALL OUTLET CONNECTIONS MAY CAUSE THE WALL OUTLET TO OVERHEAT. BE SURE THAT HEATER PLUGFITS TIGHTLY INTO OUTLET BEFORE EACH USE. DURING USE, CHECK TO MAKE CERTAIN THE HEATER PLUG ISNOT OVERHEATING. IF NECESSARY HAVE A QUALIFIED ELECTRICIAN CHECK AND/OR REPLACE THE WALL OUTLET. DONOT USE THIS HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES.• Make certain that the power source conforms to the electrical requirements of the Heater.• Extreme caution is necessary when any Heater is used by or near children or invalids . The Heater should not be leftoperating unattended. Never leave children unattended when the heater is on or plugged in.• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intendedto fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contacta qualified electrician. Do not attempt to defeat this safety feature.• DO NOT use the Heater in areas where gasoline, paint, or flammable liquids are used or stored. DO NOT use Heater in locationswhere flammable or explosive chemicals are stored, or in wet atmospheres.• Do not operate any Heater with a damaged cord or plug or after the Heater malfunctions, or has been dropped or damaged in anymanner. To disconnect Heater, turn the Heater OFF then remove the plug from the outlet.• Always unplug Heater when not in use. Unplug power cord before servicing or moving the Heater.• Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fire, ordamage the Heater. Do not block or tamper with the Heater in any manner while it is in operation.• Do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openingsmay become blocked. Do not depend on the on/off switch as the sole means of disconnecting power when servicing or moving theheater. Always unplug the power cord.Read all instructions before using this Heater.IMPORTANT SAFETY INFORMATIONWhen using electrical appliances, these instructions and warnings should always befollowed to reduce the risk of fire, electrical shock and injury to persons:WARNINGCAUTION• Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the Power Cord sothe Heater or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power Cord with throw rugs, runners, orsimilar coverings as this may cause cord to overheat. Arrange Power Cord away from room traffic and where it will not be tripped over.• This Heater is HOT when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this Heater. Keepcombustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the Heater and keepthem at least 1 foot (0.3 m) from the sides and rear.• This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and similar indoorlocations. NEVER locate a Heater where it may fall into a bathtub or other water container.• DO NOT use Heater outdoors.• This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please referto National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements forAgricultural Buildings. THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).• This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codesor standards relating to electrical requirements for Hazardous locations. THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NECARTICLE 500 (2008).NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between theequipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult thedealer or an experienced radio/TV technician for help. The user is cautioned that changes and modifications made to the equipment without theapproval of manufacturer could void the user’s authority to operate this equipment.Please contact Customer Service at 800-233-0268 Monday through Friday from 8am to 5pm EST for assistance.WARNING

/ 4

Related manuals for Lasko 6405