Laskomex MVC-6850 Installation And Activation
Page 64.6. If the number is not programmed within 30 sec the procedure will be stopped automaticallyand monitor number will not be changed.5. Checking the monitor numberTo check the monitor programmed number pushbutton LOCK should be pressed and holdedin waiting mode (no audio or video connection) and with receiver hung up. A diode will lightin colour comforms to gate drive control mode, next it will light for a moment in both coloursand then the programmed number will be reproduced according to item 4.5.6. Configuration of video lineDepending on the topology of video signal transmission system there are available threeset-ups of video line configurations. This is done by means of jumpers available in the cut-out in the rear part of monitor casing (see dwg. 2 or sticker on the monitor rear part).- BNC - set the jumper in this position if video signal is sent by a concentric cable.- UTP - set the jumper in this position if video signal is sent by UTP spiral cable.- UTP+TERMINATOR - set the jumper in this position if video signal is sent by UTP spiralcable and the monitor is located at the end of video bus bar or is the only line load.7. Monitor controlMonitor is equipped with three step control of acoustic signals (calling from external panel,calling from floor panel, door bell), colour saturation, contrast and picture brightness.Three pushbuttons on the right side of monitor are used for step control of contrast, saturationand brightness.Volume of acoustic signalization can be changed by switch on the right side of monitor.Upper position means loud signal, middle position quiet and lower position means switchedoff signalling which is also signaling by red color of signalling diode.Note!In special cases audio signal can be corrected by means of the following potentiometersavailable after the monitor rear casing has been taken off:- SPK1 - correction of loudness level of a signal coming from external panel- MIC1 - correction of loudness level of a signal going to external panel- SPK2 - correction of loudness level of a signal coming from floor panel- MIC2 - correction of loudness level of a signal going to floor panel8. Technical dataEl. supply: 13,5V DC/1AScreen diagonal: 2,36Protection degree: IP30Operating temperature: (0 40) °CDimensions: 270x80x50 mmLASKOMEX PPUH, ul. Dbrowskiego 249, 93-231 ód, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: laskomex@laskomex.com.pl, http://www.laskomex.com.plMVC-6850Installation and activation |
Related manuals for Laskomex MVC-6850
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine