2000 – 4000 Series Time Recorder User’s GuidePage 10Replacing the Type SectionIf your type section needs servicing, you can easily remove and replaceit without sending the entire machine for service.Figure 81. Remove the top cover.2. Remove Type Section Retaining Ring and Washer– Figure 8,8.1.3. If the type section has digital time display, unplug connectors(not shown).4. Lift type section slightly and move it to the right to releaseHinge Pins – Figure 8, 8.2 from their sockets. The TypeSection will lift out.2000 – 4000 Series Time Recorder User’s GuidePage 3Raise the Type Section1. Unlock the case cover and pull it forward to remove it.2. Note the position of the Release Latch and Face Setting Wheelused later in this process.3. Wait until you hear the clock “click”.4. Press either side of the Type Section Headlock – Figure 1, 1.2and pull upward on the lower part of the Clock Face until theType Section locks in the up position as shown in Figure 1.Note position of the Overthrow Lever and the Setting Wheel.5. Press the red Overthrow Lever – Figure 1, 1.3 away from youuntil it clicks. This releases the wheels allowing them to turn.Set the Time on the Type WheelsFigure 21. Locate the Center Line where all the wheels line up as shown inFigure 2.2. Rotate the wheels using a pointed object. Rotate each wheeluntil the correct date and time are aligned at the CenterPosition, as shown in Figure 2. Hint: Start at the top wheeland work down when setting.