13 - LT Series Operations ManualCHANGING THE PLATEN1. Disconnect the power source.2. Remove the top cover. Remove the framelocking pin and lift the top frame. Removethe ribbon (see Changing the Ribbon, Page11).3. Lift the printing platen assembly up and outof the frame. (Fig. 10)4. Insert the alternate printing platen assembly,using the guide pin for alignment.5. Replace the ribbon. Close the top frame andinstall the frame locking pin. Install the topcover.6. Connect the power source.7. Make a sample registration. Reset the timetype wheels and the digital display.Figure 10

Specifications

Introduction

LT Series Models

Getting Started

Setting the Type Wheels

Setting the Digital Display

Adjusting Print Impact

Consecutive/Duplicate Count

Adjusting the Registration Position

Changing the Ribbon

Changing the Fuse

Changing the Platen

Warranty

Lathem LT Series User Manual

LT Series

LTTC

LTTN

LTTNC