INVERTER OPERATIONInverter FeaturesCircuit Breaker ON/OFF SwitchThe circuit breaker is designed for ease of operation and safety. By pushingthe switch “UP”, the battery supply is connected to the inverter. The circuitbreaker will turn OFF automatically if too large a load is left on the invertercontinuously. Reset the switch after allowing approximately 5 minutes to cool.If the inverter shuts down due to over load, under volts or over volts it can bereset by turning the circuit breaker OFF, waiting 10 seconds (or until LED goesout), then turning it on again.FanIf the temperature inside the inverter reaches preset levels,the dual speed fan will switch on initially in low speedand then into high speed if the temperature continuesto increase. Obstruction of the air intake and output willreduce the power rating of the inverter.3 Terminal Input Junction BoxFor connection of a.c. input power e.g. fromgenerator.(Available only on KX model inverters).3 TerminalOutput Junction BoxFor distribution ofoutput powerBatteryLeadsBlack = NegativeRED = Positive11