Lattoflex 382 Manual
                    | |
8123Installation instructionsFrame type and serial numberThe name plate is located at the headend on the left longitudinal beam belowthe raised head.Supplied accessoriesInstallation accessories: mattress holder(foot end), 4 non-slip foilsConnection accessories:mains adapter, lead cable, control box,cable hand switch (x82),radio remote control (x83 und x84)Placing in a bedPlease heed the necessary space for theadjustable frame parts, e.g. in roomswith inclined roofs, superstructures overthe bed or padded head sections. Aninstallation depth of approx. 14 cm (floorclearance) is needed in the substructurefor the adjustment mechanism and drivesystem.Please always heed the spacing of theback part with its motorised adjustment,to the head part of the bed. There shouldbe spacing of at least 1.5 cm herewhen the bed is laid flat. To rule out anyunintentional slipping, please screw theframe to the bed at the pre-drilled pointsin the metal substructure.Side support sections must not exceed4 cm in width (middle frame 8 cm). Themotor frame must always fit in the bedwithout any tension. For beds with trian-gular supports (leg length max. 15 cm),please use the „Extension elements“ in-stallation kit (available as accessory). Fora stable bed structure, we always recom-mend a supporting point in the middle ofthe bed for triangular supports.Non-slip foilAffix in the bed structure to the supportingpoint of the frame. The foils prevent any noi-se that could be caused by the frame slippingin the bed structure.Mattress holderAttach the supplied holder at the foot end.The plastic clamps are premounted.2-Motorer (x82)mit KabelhandschalterPlease proceed as follows tocommission your motor frame:1 Transport protection: Remove theVelcro ® fastenings and the card-boards under the frame.2 Hinge up the foot part of the frame,access to the black fabric pocket3 Unpack control box and poweradapter.4 Connect motor frame to mains.5 Control box can be pushed onto thethigh motor at the side.Adjust motor frame with cable handswitch.Connection and commissioning |
Related manuals for Lattoflex 282
manualsdatabase
Your AI-powered manual search engine