Led Lenser NEO Operating Instructions Manual

Contents

Led Lenser NEO Operating Instructions Manual Manual pdf 13 page image

Led Lenser®*EN Operating instructions NEO_V.01 | 7/31/2014 135.1 Adapting the Headband Width1. In order to extend the headband ④ further, hold theband adjustment ③ between the fingers and pull theheadband ④ in direction of the battery cover ⑥ until theheadband ④ has reached the desired length.2. In order to adjust the headband ④ tighter, hold theband adjustment ③ between the fingers and pull theheadband ④ in direction of the lamp head ① on theoutermost part of the adjustable band range ② until theheadband ④ has reached the desired length.3. Move the battery box ⑧ with battery cover ⑥ in such away that the battery box ⑧ is facing the lamp head ①.4. Move the cable duct ⑦ in such a way that the cable ⑤ isslack against the headband ④.5.2 Putting on the Headlamp1. Align the headband ④ in such a way that the cables ⑤are on the outside.2. Press the curved lamp head ① rear up against theforehead using one hand.3. Using the other hand, pull the battery cover ⑥ backwardgently and pull it with the headband ④ downward overthe back of the head.→ Take care to ensure that the anatomically shaped rearof the battery cover ⑥ is in place on the back of thehead.4. If necessary, move the battery box ⑧ with the batterycover ⑥ or cable ducts ⑦ in such a way that theheadlamp fits comfortably.5. Adapt the width of the headband ④ according to Chap.5.1 as required.5.3 Switching the Headlamp On or Off1. Press the On/Off switch ⑨ on top of the lamp head 1x toswitch the headlamp ① on.2. Press the On/Off switch ⑨ on top of the lamp head oncemore to switch the headlamp ① off.NOTESWITCHING OFFThe headlamp can only be switched off after 2-3seconds because the lighting functions wouldotherwise be enabled.5. Operation683.2.1.4 75 61 832 4 5 6 7191