Led Lenser®*EN Operating instructions P6X_V.01 | 7/31/2014 14is activated. Use this method to select from the followingprograms:Program APress the push button Light function1 x High Power2 x Power (normal)3 x Low Power (dimmed)Program BPress the push button Light function1 x Low Power (dimmed)2 x Power (normal)3 x High Power1. Switch flashlight off.2. To change the lighting program, press the On/Off pushbutton 8 times (or more) and then engage.→ The flashlight switches the lighting program andindicates this by briefly flashing twice.→ After the flash, the first lighting function for therelevant program will be selected, thus, either HighPower or dimmed light will be used.→ Repeating the process switches back into the otherlighting program.5.6 Replacing the Batteries/Battery Pack1. To remove the battery pack② unscrew the end cap ③.2. Remove the batteries/battery pack ②, dispose of thebatteries appropriately and replace, recharge batterypacks.CAUTIONRISK OF eXPLOSIONAlways insert batteries/battery packsaccording to the (+/-) markings as thereis otherwise a risk of damaged or evenexploding batteries.3. New batteries/battery packs ② must be inserted with theplus pole (+) first into the battery compartment ①.4. Screw the end cap ③ back into place.ATTeNTIONUSING BATTeRIeS/BATTeRY PACKSThe flashlight may only use 2 x AA batteries (LR6)or 2 x AA NiMH battery packs with 1.5 V.5. Operation+ -AA Alkaline + -AA Alkaline+ -AA Ni-MH + -AA Ni-MHLED LENSER®* P6X321