Startup and shutdownTo start the drive:1. Turn the speed adjust potentiometer full counterclockwise(CCW), or set the voltage signal to zero.2. Apply DC voltage input.3. Slowly advance the speed adjust potentiometer clockwise (CW),or increase the voltage signal. The motor slowly accelerates asthe potentiometer is turned CW or the voltage signal isincreased. Continue until the desired speed is reached.4. Remove DC voltage input from the drive to coast the motor to astop.If the motor or drive does not perform as described, disconnect theDC voltage input immediately. Refer to the Troubleshooting section(page 33) for further assistance.16 Operation
