Leisure bay spas Smart S-3 Series Owner's Manual
                      | |
Contents
| 
Personal Comfort Control ConsoleThe Leisure Bay Personal Comfort Control Console is your direct link to the most sophisticated solid state spa control center available. With a simpletouch of the finger you can select any spa’s functions from turning on the lights to powering up the jets. This state of the art control console allows youto program the spa’s various operating functions to suit your individual needs by following the user friendly directions which follow. Should you have anyquestions regarding operations please contact your local Leisure Bay dealer.WARNING: SHOCK HAZARD! NO USER SERVICEABLE PARTS. Do not attempt service of this control. Contact your dealer or servicecenter for assistance. Follow all owner’s manual power connection instructions. Installation must be performed by a certified licensedelectrician and all grounding connections must be properly installed.S-3 Series Control12Initial Start-UpWhen your spa is first activated, it will perform a self diagnostics testshowing a series of numbers followed by Pr, —F, including a 5 minutespump purge cycle. Also an internal 24 hour clock that keeps track ofthe purge cycles starts. This test will take approximately 13 minutes.The system is preset from the factory to heat up to 100°F, but once theself diagnostics test is completed it is okay to change the preset temp.Temperature Adjustment 70°-104°FWhen either of the temp pads or is touched once, theLCD will flash and display the temperature which has been set. Whileflashing, press the temp pad again to increase or decrease thetemperature. The temperature will change from 70°-104°F in 1°increments. After 5 seconds, the LCD automatically will display thecurrent spa temperature.JetsPress the pad to turn the pump on and off. If left running, thepump automatically will turn off after 15 minutes.Freeze ProtectionIf the high-limit sensor detects 44°F at the heater, then all the equipmentautomatically is activated to provide freeze protection. This is a normalspa function; no corrective action is necessary. The equipment stayson until the sensor detects 45°F at the heater. Freeze protection isenabled regardless of the spa mode status. See also page 4.Standby ModeThe spa can be disabled when the filter needs to be replaced. To put thesystem in standby mode, press the pad then the pad andthe display will show “58”. All spa functions are disabled except forfreeze control. Press any panel button to resume spa operation.Display Messages (see page 16)LightsPress the button to switch the spa light On or Off.These state of the art digital lights have various color operation modes:1. Red2. Yellow3. Green4. Aqua5. Blue6. Purple7. White Party Mode: Produces Random colors and flashingpatterns8. Color Wheel: Smooth color changing pattern.To switch modes, simply press the button to Off for no lessthan 2 seconds, then On to advance the to the next mode. If they arepressed too soon, the lights could get unsynchronized.To synchronize, leave the lights in the off position for 4 to 8 seconds,the lights will flash three times at which point all the lights will be at thesame mode.These lights have a memory that when switched off for more than 8seconds, they will power up in the last mode that was selected. Thisallows the user to leave the lights in a favorite mode without having tohunt for it when powering up the lights.Spa Water MaintenanceThe spa water is constantly maintained by a 24HR circulation pumpand a programmed purge cycle that clears the pluming lines for 30seconds every 12 hours from the time the spa is energized.FOR ADDITIONAL FEATURES (see page 15)PUMP SPA LIGHT HEAT MODES(SEE PAGE 15)TEMP UPTEMP DOWN |
Related manuals for Leisure bay spas Genius G-2.5
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine