40During the assembly of the loom the brake pedal was adjusted horizontally. After using it for sometime, you will find that the brake pedal has come up a little. Check the cap nut of the carriage bolt,the hinge point of the pedal, and make sure that the nut is tight.Adjust the brake pedal a little lower, back to a horizontal position:Stand beside the loom and push the pedal down. Slip over the brake disk side one winding of thecable, so that the tension is released. Now let the pedal go and have both hands free for adjustment.Take the cable loop from the threaded hook and twist the hook clockwise for several rotations. Hookon the loop again and push down the pedal so that you can replace the cable onto the disk. Checkagain the height of the pedal.The warp does not come loose from the warp beam when the warp is advancedPossible causes- The brake pedal has to be pushed in further.- The warp tension you use for your project is too low to pull the warp from the warp beam.This can happen if you make a small cloth from fragile material. In this case you will need toadvance the warp beam a little by hand, while you push the brake pedal. If you weave with a lowwarp tension, the lease sticks, if left in the warp, could give too much restriction to allow the warp tobe moved forward. Remove the lease sticks from the warp.The cloth cannot be wound onto the cloth beamPossible causes:- One of the ratchets is not locked into the ratchet wheel of the cloth beam.- The apron rod of the cloth beam hits one of the spring arms.The roller of the mechanical dobby does not come into the next position completely whenyou push down the treadlePossible causes:- You do not push in the dobby treadle far enough.- The cord between the treadle and the reversing disk is too loose or too tight.- The position of the reversing disk is not properly adjusted.- The cords connecting the reversing disk to the anchor are not properly positioned over therollers.With the mechanical dobby, the knife is stuck between the screw heads of the dobby hooksPossible cause:- You moved the dobby by hand while you kept the treadle for the shed pushed in.You can eliminate the problem by turning the roller of the dobby head half way between twopositions and moving the knife up and down with the treadle for the shed. All the screw heads willcome free. When the knife is all the way up again, you turn the roller into a fixed position.Warrantee and contactLouët products are known worldwide for their excellence in quality, design and workmanship. Manyof our customers are happy to own more than one Louët product. We stand behind our products tothe fullest extent possible and guarantee each product is free from manufacturing defects. We andour distributors will work with you, to the best of our abilities, to ensure that you are content with yourpurchase. If you still have a question after reading this manual, please contact your dealer or Louëtdirectly.Louët BVKwinkweerd 1397241 CW LochemThe NetherlandsPhone: + 31 (0)573-252229Fax: + 31 (0)573-253858Email: info@louet.nlWebsite: www.louet.nl