LumaPro 52YK79 Operating Instructions Manual
    | |
WARNING: UNPLUG UNIT BEFORE ATTEMPING ANY MAINTENANCE!Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth anda mild soap, if needed. Be sure not to get the electrical plug wet. NEVERsubmerge any part of the Work Light in any solution to clean it. DO NOT USEsolvents such as gasoline, turpentine, etc., to clean unit.DRY THOROUGHLY BEFORE PLUGGING BACK INTO OUTLET!1. DO NOT handle this fixture or try to plug it in when your hands are wet ordamp. DO NOT handle this fixture or try to plug it in when you are standingon a wet or damp surface or in water.2. This fixture MUST ALWAYS BE USED in accordance with all electrical andsafety codes and ordinances, including the most recent National ElectricCode (NEC) and with the Occupational Safety and Health Act (OSHA)Volume 1 on General Industry Standards and interpretations.3. ALWAYS make certain that the power source conforms to the requirementson the fixture.4. ALWAYS disconnect the power before servicing or inspecting the fixturefor any reason.5. This fixture is ONLY FOR USE ON 110V-120V (single phase) and isequipped with an approved polarized plug.6. IMPORTANT SAFETY INSTRUCTIONS-this product has a polarizedattachment plug (one blade is wider than the other).This plug fits in apolarized outlet only one way. If the plug does not fit fully in the outlet,reverse the plug. If it still does not fit, contact a qualified electrician.NEVER use a extension cord, unless the plug can be fully inserted. DONOT IGNORE THIS WARNING.7. FIXTURE IS NOT WATERPROOF and is not intended for use in showers,saunas or in potentially wet locations. The entry of moisture into the lightmay cause damage and void the warranty.8. This fixture is for INDOOR USE ONLY. DO NOT use in flammable orexplosive atmospheres. Potential ignition may occur.9. NEVER LOOK DIRECTLY INTO LIGHT SOURCE. LEDs are extremelybright and can damage eyes with prolonged exposure.10.NEVER operate the light with the clear protective lens removed.11.KEEP AWAY from heating vents, radiators, or other sources of heat.12.KEEP OUT OF REACH OF CHILDREN.OPERATING INSTRUCTIONSLED Hand LampWARNING: To avoid serious injury or death from electricalshock or fire.SPECIFICATIONSDual Multi-position hanging hooks can be positioned for vertical or horizontalmounting, and can rotate 360° for precise positioning.Magnet Clip clings to most metal surfaces.CAUTION: Read all instructions and warnings before Operating!SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!Printed in China Form #: 5S7548Ver: 0 12/16 9669 ALE100Model No: 52YK79,2YKN1A, 2YKN2A, 2YKN3A, 2YKN4AHANGING WORK LIGHTOperation: Plug into any 110-120V standard wall outlet, press switch in thehandle to turn the light on. Press again to turn off.MAINTENANCEManufactured for Grainger International, Inc.100 Grainger Pkwy., Lake Forest, IL 60045 U.S.A.Model Cord LengthLumens Cord Type/Gauge Maximum Rating4.5W, 0.07Amp, 120V, 60Hz4.5W, 0.07Amp, 120V, 60HzSJT 18/2SJT 18/225 Ft300 lms50 Ft300 lms2YKN1A4.5W, 0.07Amp, 120V, 60HzSJT 18/210 Ft300 lms52YK792YKN2A7.5W, 0.10Amp, 120V, 60HzSJT 18/225 Ft500 lms2YKN3A7.5W, 0.10Amp, 120V, 60HzSJT 18/250 Ft500 lms2YKN4A2YKN2A2YKN1A52YK792YKN4A2YKN3A |
manualsdatabase
Your AI-powered manual search engine