Lumel N43 User Manual & Quick Start

Also see for N43: User manual

Contents

Lumel N43 User Manual & Quick Start Manual pdf 31 page image

31314.4 MEASURE ModeIn Measure mode the values are displayed according to thepages that are preset at the factory or configured by the user in PagesProgramming PAG.Changing the page is done by pressing the or .The sequence of displayed pages is according to a table created in PAGmode.Entry into monitoring of maximum and minimum values modeoccurs when pressing at the same time the buttons andfor at least 3 seconds. Erasing maximum and minimum values is doneby pressing the button while monitoring their value.Alarms areactive if they were allocated. Note that the alarms do not need to beassociated with quantities displayed on the page because the change ofa page would result in action on two-state outputs.Erasing alarm signalization latch / if it was set in the Alarm parametersmode Aln / is done by pressing the buttons .When reactive power or energy is displayed, this indication is accompa-nied by a symbol of the inductive load or capacity load .When active energy is displayed, this indication is accompanied by asymbol of active energy export or active energy import.EN