136.1. Programming Controller ParametersThe pressure and holding down the push-buttonduring ca 2 sec. causes the entry in the programming matrix. The pro-gramming matrix can be protected by an access code. In case whengiving a wrong value of the code, it is only possible to see settingsthrough – without the possibility of changes.The fig 14. presents the transition matrix in the program-ming mode. The transition between levels is carrying out by meansof or , push-buttons and the level selection by means ofthe push-button. After selecting the level, the transition betweenparameters is carried out by means of or push-buttons.In order to change the parameter setting, one must proceed acc.to the section 6.3. In order to exit from the selected level, one musttransit between parameters until the symbol [. . .] appears and pressthe push-button.In order to exit from the programming matrix to the normalworking mode, one must transit between levels until the symbol [. . .]appears and press the push-button.Some controller parameters can be invisible – it depends onthe current configuration.The table 1 includes the description of parameters. The returnto the normal working mode follows automatically after 30 seconds sincethe last push-button pressure.