Luminor LB4-031/2 Owner's Manual

Contents

Luminor LB4-031/2 Owner's Manual Manual pdf 10 page image

10 | P a g eStep 15: Carefully insert the UV lamp into the reactor sliding it inside the quartz sleeve located inside the reactor(do not drop the lamp into the reactor). Affix the LUMI-Loc™ connector into the gland nut by inserting theconnector into the nut and turning the connector approximately ¼ turn to lock the connector to the gland nut.Figure 8. LUMI-Loc™ ConnectorStep 16: Affix the captive ground screw to the ground lug on the UV reactor to ensure proper grounding continuity.Figure 9. Ground Screw ConnectionStep 17: Your system is now ready to be plugged into the appropriate GFCI protected outlet. Plug the unit in andrefer to the “System Disinfection” section before any water is allowed to flow through the system.System Disinfection:Now that the system is installed you will need to disinfect the lines throughout the entire home or facility. Toaccomplish this, please follow these simple steps:Step 1: Before performing this task, check to make sure that there are no “dead ends” in the lines throughout thehome as these can harbor bacteria. Also ensure that the UV system is powered-up and ready for operation beforeyou start this disinfection process.