14Live ModeYou can use this interface as a live controller to send DMX data viaMADRIX ®. You can either use 2x DMX-OUT, or 2x DMX-IN, or 1x DMX-OUTand 1x DMX-IN, or Art-Net in Live Mode.Please make sure to install the MADRIX® software first. Afterwards, pleaseconnect the PLEXUS directly to a free USB 2.0 port of your computer or usethe USB power supply (or USB 2.0) and the network connection for Art-Net.If the MADRIX® PLEXUS driver has been installed properly, the status LEDswill light up accordingly, as described on page 9. Start the MADRIX ®software now if not yet done.Configuration of the DMX-OUT or Art-Net functionality can be set up directlyin MADRIX ® using the 'Device Manager'. In MADRIX ®, navigate to the menu'Preferences' Æ 'Device Manager' Æ 'DMX Devices', and Æ 'Art-Net' (ifneeded). Also remember to configure your virtual light matrix in the menu'Preferences' Æ 'Matrix Generator' or 'Preferences' Æ 'Patch'.For more information, please read the user manuals.Using MADRIX ® PLEXUS As DMX-IN InterfaceYou can use this interface to receive DMX data via MADRIX ®. For DMX-IN,please use a Male to Male 3-pin or 5-pin XLR Gender Changer if necessary.Configuration of DMX input can be set up directly in MADRIX ®.In MADRIX ®, navigate to the menu 'Preferences' Æ 'Device Manager' andselect the tab 'DMX Devices'. Select your interface and activate 'Enable' aswell as 'Input' in the 'Settings' section. Press 'Apply'.In the next step, configure your PLEXUS to control MADRIX® remotely under'Preferences' Æ 'Device Manager' Æ 'DMX Input'. Choose an entry in the list(Universe 1 to 8), select your 'DMX-IN Device', and activate 'Remote'. Then,choose one of the input protocols in the section 'Remote Control' and press'Apply'. Close the window with 'OK'.For more information, please read the user manuals.