16Z Series User Manual rev 2.10info@mag-audio.comTel./Fax: +38 044 277-47-89 www.mag-audio.com5.9.1. Mains connection.Z series powered systems are supplied with CN-0010 PowerCon-E/F CEE 7/7 mains cable (part number0204000003). Use only original or supplied by manufacturer mains cables!Z series powered systems are equipped with PowerCon B mains power outlets for mains link toadditional Z series powered system.Z series systems’ nominal mains power specifications: AC 220V, 50/60 Hz.Nominal voltage tolerance: 100 - 250 V.To power up the system, connect the mains cable to the system, then to the power outlet.To completely power down the system, disconnect the mains cable from the power outlet.5.9.2. Signal connections.Z series systems are equipped with XLR INPUT an XLR LINK connectors for signal connection.Use of balanced XLR connector cables is recommended. In case when balanced XLR connections are notavailable, unbalanced XLR connection is acceptable.For linking the additional system to the same signal bus LINK connector may be used.123Shield (Ground)Plus (+)Minus (-)Balanced XLR Plug connections123Shield (Ground)Plus (+)Shield (Ground)Unbalanced XLR Plug connectionsXLR-XLR cable XLR-XLR cableZ series poweredfull-range systemZ series poweredfull-range systemZ series poweredsubwooferZ series poweredsubwooferXLR-XLR cable XLR-XLR cableTo signal sourceZ series powered connection diagramAmplifier controls. Use several available Zseries speaker system’s amplifier controlsto set up the entire system:BT/User EQ (full-range system): EnablesBlueTooth controls for BlueTooth enabledversions. Engages HF boost filter forfarfiled applications for versions withoutBlueTooth support.NORMAL/MONITOR MODE. (full-rangesystem): Provides additional microphonefeedback suppression for moreperformance comfort while using as stagemonitor.HPF (full-range system): Provides high-pass filter to seamlessly couple the full-range system with powered subwoofer.BT/User EQ (subwoofers): EngagesBlueTooth controls on BlueTooth enabledversions. Engages custom LF boost to addmore “kick“ to the system performance.PHASE (subwoofers): Switches the polarityof the subwoofer for better couplingwith the full-range systems for differentapplications.LPF (subwoofers): Provides low-pass filterto seamlessly couple the subwoofer withpowered full-range system.