MAHLE FluidPRO ATX-3 PLUS BOOST Operation Manual
                       | |
Page 10-1/2 LITER1. Vehicle engine is running and the ATX-3 PLUS BOOST is connected as previously described, READYlight is illuminated.2. Check transmission dip stick. Press the -1/2 LITER button to lower the fluid level if the transmissionsystem is overfilled.3. When process is complete the buzzer will sound continuously and the PROCESS COMPLETE light willstay illuminated until the STOP button is pressed.4. Check transmission dip stick for appropriate level.+1/2 LITER1. Vehicle engine is running and the ATX-3 PLUS BOOST is connected as previously described, READYlight is illuminated.2. Check transmission dip stick. Press the +1/2 LITER button to raise the fluid level if the transmissionsystem is under filled.3. When process is complete the buzzer will sound continuously and the PROCESS COMPLETE light willstay illuminated until the STOP button is pressed.4. Check transmission dip stick for appropriate level.DISCONNECTING FROM THE TRANSMISSION SYSTEM- Caution -Hoses, fitting adapters and the engine may be extremely hot. Useextreme caution when disconnecting.1. Turn vehicle engine off. READY light should go off. Make sure READY light is OFF before proceeding.2. Disconnect ATX-3 PLUS BOOST from the vehicle battery.3. Disconnect 10 ft black and red hoses from the 12 inch adapter hoses.4. Disconnect 12 inch adapter hoses from fitting adapters connected to the transmission system.5. Disconnect fitting adapters from the transmission system connection points.6. Reconnect cooler lines. Do not cross-thread cooler line fittings when reconnecting to the transmissionsystem.7. Start vehicle engine and check for leaks at cooler line connection points, tighten if necessary. Vehicletransmission service is complete once transmission system is leak free.GOOD PRACTICEEmpty used fluid tank after every exchange procedure. |
Related manuals for MAHLE FluidPRO ATX-3 PLUS BOOST
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine