Maestro M111 User Manual

Maestro M111 User Manual Manual pdf 35 page image

Chapter 7REMOTE CONTROL COMMANDS7.1 AT#SMSATThis feature is to control the modem to interpret AT command from incoming SMS, executing it, and return the resultto sender by SMS. The user can enable the modem to receive AT command by incoming SMS.Description of the operation:Figure 7.1.1: Example of remote AT command by SMS1. When enabled, the modem will treat the incoming SMS as a source of AT command only if all of the followingconditions (a, b and c) are fulfilled:(a) The content of SMS sent to the modem is using standard 7-bit GSM data decoding scheme(b) The first 6 characters of the SMS content matches the parameter set by AT+SMSAT command(default key is “000000”)(c) The 7th and 8th characters of the SMS content is “AT” (in capital letters).2. If SMSAT is enabled, the modem will read each incoming SMS, if the conditions mentioned in 1 are matchedthe message will be executed, even it is an invalid AT command.3. When using SMSAT feature, only +CNMI: x, 1, x, x, x setting could be used (i.e. incoming message will bestored in SIM card).4. The maximum length of the AT command is limited by length of SMS, i.e. 160-6 = 154 characters.5. When the SMS AT command is executed, all intermediate and final Read Responses will be buffered recorded,then return to the sender’s phone number in one single SMS.6. If Read Response(s) of the AT command is (are) more than 160 characters, only the first 160 characters will bereturned.Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.Please contact us on support.maestro-wireless.com35