Mafell K 65 cc Original Operating Instructions

Contents

Mafell K 65 cc Original Operating Instructions Manual pdf 22 page image

-22-can be read off the scale 14 (Fig. 1). The rivingknife/splitter swings up and away when theblade enters the workpiece. As soon as the slitbehind the saw blade is cleared during theforward motion of the machine, the riving knifereverts to its normal position.In case of repetitive plunge cuts ofthe same depth, the plunging depthcan be preset.Proceed as follows: Set the machine to the desired cutting depth. Open the clamping screw 17 (Fig. 2) and set thestop bar 18 (Fig. 2) downwards up to the limitstop. Retighten the clamping screw. After completionof the plunge work, set the stop bar into the topposition.5.6 Sawing according to tracingsThe retractable marking indicator 19 (Fig. 1) isautomatically adjusted for bevel cuts as well. Thetracing edge corresponds to the saw blade's inside.For diagonal cuts, the marking can be viewed throughthe opening on the left-hand side of the upper sawguard (arrow, fig. 1). Hold the machine by its handles and place thefront part of its base plate onto the workpiece. Switch on the portable circular saw (see chapter5.2) and slide the machine evenly forward in thedirection of the cut. When the cut is completed, switch off the sawby releasing the switch trigger 10 (Fig. 2).5.7 Sawing with parallel stopThe parallel stop serves to saw parallel to an alreadyexisting edge. The limit stop can be attached to theleft or right of the machine. While doing so, the cuttingrange amounts to 33 - 130 mm on the right-hand side(reading indicator "X" Fig. 1) and to 163 - 300 mm onthe left-hand side (reading edge at indicator edge "Y"Fig. 1). In the range of 163-220 mm, the machinemust be adjusted upwards by approx. 10 mm so thatthe limit stop can be pushed under the motor casing. You can adjust the cutting width after releasingthe wing screws 20 (Fig. 2) by moving the limitstop accordingly and afterwards retightening thewing screws.In addition, by simply turning it around (guide face forthe workpiece edge points upwards), the parallel stopcan also be used as double support to improveguidance of the portable circular saw. Now themachine can be guided along a guide that is fastenedon the workpiece.5.8 Working with the roller edge guideThe roller edge guide serves to work parallel to analready existing edge. The limit stop can be attachedto the left or right of the machine. The cutting rangeon the right-hand side amounts to approx. 12 - 40 mmand on the left-hand side to approx. 30 – 210 mm. You can adjust the cutting width after releasingthe wing screws 20 (Fig. 2) by moving the limitstop accordingly and afterwards retightening thewing screws.6 Service and maintenanceDangerPull the power plug during allservice work.MAFELL machines are designed to be low inmaintenance.The ball bearings used are greased for life. When themachine has been in operation for a longer period oftime, we recommend to hand the machine in at anauthorised MAFELL customer service shop forinspection.Only use our special grease, order No. 049040 (1 kgtin) for all greasing points.6.1 StorageIf the machine is not used for a longer period of time,it has to be carefully cleaned. Spray bright metal partswith a rust inhibitor.