Magellan MAP410 Frequently Asked Questions Manual

Also see for MAP 410: User manual

Map 410 GPS FAQs1 Question: How many batteries does my Map 410 GPS use?Answer: Map 410 GPS uses four AA batteries.2 Question: How long will the batteries operate for my Map 410 GPS?Answer: Using four AA batteries, your Map 410 GPS will operatecontinuously for up to 12 hours.3 Question:How long will my Map 410 GPS keep memory active without abattery?Answer:The internal lithium backup battery will keep your receiver’smemory active for up to 10 years.4 Question: How do I install the batteries in my Map 410 GPS?Answer:The Map 410 GPS uses four AA alkaline batteries that areinstalled from the bottom of the receiver. Use the rings tounscrew the water seal battery caps. Insert the batteries intothe battery tubes, with the positive end first, two batteries ineach side, and screw the battery caps until securely closed.Although it is recommended that four AA batteries be used, incase of an emergency the receiver will operate with only twobatteries if both are inserted into one of the battery tubes.5 Question: How do I turn on my Map 410 GPS?Answer:To turn your Map 410 GPS “on”, press the power/light key andthen press the enter key when prompted. If the enter key is notpressed within 10 seconds of being prompted, the receiver willturn “off”. Wait for the unit to scroll through the start-upscreens.6 Question: How do I turn off my Map 410 GPS?Answer:To turn your Map 410 GPS “off”, press and hold the samepower/light key. This will start a shutdown sequence thatcounts down the seconds until the receiver actually turns“off”. To immediately turn the receiver “off”, release and pressthe power/light key again. To cancel the shutdown sequence,press any other key.7 Question: How do I initialize my MAP 410 GPS for the first time use?Answer: Turn your receiver on by pressing the power/ light key and theenter key, when prompted. Because this is the first time you