14Installation SourceInfoSettingsAutoprogramSourceClockWeak channel installationCurrent software infoLanguageReset AV settingsTVAV1AV2HDMIPCInstallation ClockInfoSettingsAutoprogramSourceWeak channel installationCurrent software infoLanguageReset AV settingsClock: AM-- --Installation Reset AV settingsInfoSettingsAutoprogramSourceClockWeak channel installationCurrent software infoLanguageReset AV settingsStart nowSelect Source in the Installation menu.Press the cursor right to enter the list, and press up/down key tothe selected input.Press OK button to confirm.Analog Audio InIf your accessory device has a DVI output connector, only thevideo signal is transmitted in digital format. To input an audio signal,please connect the analog audio L and R outputs to the TV’s L andR AV2 audio input plugs.Digital Audio OutIn addition to accepting audio input through HDMI, the TV canoutput Digital audio through the DIGITAL AUDIO OUT(SPDIF OUT) connector to an external amplifier or receiver.If your amplifier or receiver has a matching connector for DigitalAudio In, you can connect it with a single cable to the TV’sDIGITAL AUDIO OUT (SPDIF OUT). See Cover and Connection.SourceHDMIDVI AV2:Audio L/RCVBSS-VIDEORLPC INVGAPrPbRLYRLDVIHDMI123ClockInstallation SourceInfoSettingsAutoprogramSourceClockWeak channel installationCurrent software infoLanguageReset AV settingsTVAV1AV2HDMIPCInstallation ClockInfoSettingsAutoprogramSourceWeak channel installationCurrent software infoLanguageReset AV settingsClock: AM-- --Installation Reset AV settingsInfoSettingsAutoprogramSourceClockWeak channel installationCurrent software infoLanguageReset AV settingsStart nowThis menu allows you to identify the accessory devices you haveconnected to the external inputs/outputs.This allows you to use your TV as a clock.Press the MENU button on the remote control.Use the cursor down to select Installation in the Settings menu.Press the cursor right to enter the list, and press up/down key toset the time. (hour/ minute/ AM or PM)Press OK button to confirm.1234