26PC menu-InstallationInstallation LanguageInfoEnglishFrançaisSettingsSourcePicture adjustmentFactory resetEspañolLanguageInfoSettingsInstallation SourceTVAV1Picture adjustmentFactory resetAV2HDMIPCLanguageSourceInstallation Picture adjustmentInfoAuto adjustManual adjustSettingsFactory resetLanguageSourcePicture adjustmentSettingsInstallation Factory resetInfoSettingsLanguageSourcePicture adjustmentFactory resetStart nowSelect the menu languagePress the MENU button on the remote control.Use the cursor down to select Installation in the Settings menu.Use the cursor right to enter the Installation menu.Select Language and enter the list of available languages with thecursor right.Select your preferred language with the cursor up/down and pressthe OK button to confirm your selection.Proceed with the Installation menu.123456SourceSelect Source in the Installation menu.Use the cursor right to enter the Source menu.Select PC with the cursor up/down and press the OK button toconfirm your selection.123Picture adjustmentSelect Picture adjustment in the Installation menu.Use the cursor right to enter the Picture adjustment menu.You can choose Auto adjust or Manual adjust with cursor up/down and press OK button to confirm.123Auto adjustAutomatically adjust to the best image position, phase andclock setting.Manual adjustManually fine tune the image as it appears on the screen.• PhaseEliminates the horizontal interfering lines.• ClockEliminates the vertical interfering lines.• HorizontalAdjust the horizontal placement of the picture.• VerticalAdjust the vertical placement of the picture.Factory resetSelect Factory reset in the Installation menu.Use the cursor right to enter the Factory reset menu.Press the OK button to erase settings and reset them to theirdefault values.123This function allows you to reset most of the picture and soundsettings to their default factory levels.Note: Press SOURCE button on the remote control to make sure the source isselected in PC mode.