No sound ● Check if the unit is connected securely.● Make sure the TV or amplifier is working properly.● Make sure the amplifier is set to receive DVD signaloutput.Bad sound quality ● Make sure the audio output mode is set correctly.● Make sure the audio connection between the unit andamplifier is in place.No image ● Check if the unit is connected securely.● Make sure the TV is working properly.● Make sure the color system is set correctly.This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and otherintellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technologymust be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwiseauthorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.● Remove barriers between the remote control and theunit.● Point the remote control at the remote control sensorof the unit.● Replace the batteries with new ones.Remote control does not work● Disconnect the power plug and insert it into the walloutlet again.The unit doesn't operate normally● There is no disc in the unit.● Put the disc on the disc tray properly with the labelside up.● Clean the disc.● Moisture has condensed in the unit. Remove thedisc and leave the unit on for about an hour.Disc cannot be playedIf you experience the following problems while using the unit, this troubleshooting guide can help you.page44Troubleshooting