Magnavox 26MF337B User Manual

Also see for 26MF337B - Hook Up Guide: Getting started guide User manual Specification User manual

Magnavox 26MF337B User Manual Manual pdf 19 page image

12TV menu-InstallationInstallation LanguageInfoEnglishFrançaisSettingsAutoprogramSourceClockWeak channel installationCurrent software infoReset AV settingsEspañolLanguageTelevision InstallationYou can now start automatic installation. Thisprocedure can take more than half an hour.Previous StartAutoprogramInfoSettings I InstallationCable Start nowAntennaAntennaNotes:• When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code inorder to complete Autoprogramming.• When channel update is interrupted, the new updated channel information is retained along with the old un-updatedchannel information.• Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.• If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequenciesand update information.• Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thusoptimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 13.)• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.• If Antenna/cable signal is interrupted more than 30 minutes, TV will go into off mode. You are requested to press Power buttonor CH + / - button to turn on the TV.Select the menu languagePress the MENU button on the remote control.Use the cursor down to select Installation in the Settings menu.Use the cursor right to enter the Installation menu.Select Language and enter the list of available languages with thecursor right.Select your preferred language with the cursor up/down and pressthe OK button to confirm your selection.Proceed with the Installation menu.123456Select Autoprogram in the Installation menu.Use the cursor right to enter the Autoprogram menu.Select Cable or Antenna in the Installation mode.When Antenna is selected, the TV will detect antennasignals and will search for antenna TV (NTSC and ATSC) channelsavailable in your local area.When Cable is selected, the TV will detect cable companysupplied signals and will search for cable TV (NTSC, ATSC, QAMmodulated) channels available in your area.Make sure that registration with your cable TV provider andconnection of equipment are completed.Select Start now with the cursor right key.Press the OK button.Press the green button “Start” to start Autoprogramming. Themenu screen disappears and the progress of Autoprogrammingis displayed. The progress bar indicates the number of analog anddigital TV channels found.Auto programming may take up to 20 minutes to complete. Digitalchannels will take longer than Analog to find and program. Pleasewait until you see the Auto Programming complete message. TheTV will then switch automatically to the first channel found.Note: All channels must be unlocked in order to autoprogram. Ifrequested, enter your PIN code to unlock all channels. (p. 25)123456Store TV channels