Magnavox 27MDTR10S Service Manual

Also see for 27MDTR10S: Owner's manual

1-8-2 TD603DCReference Notes in the TableCaution !When removing the CRT, be sure to discharge theAnode Lead of the CRT with the CRT Ground Wirebefore removing the Anode Cap.Reference Notes in the TableCAUTION 1: Discharge the Anode Lead of the CRTwith the CRT Ground Wire before removing the AnodeCap.1. Disconnect the following: Anode Cap, CN501, CRTCBA, CN571, CN2602, CN1301 and CN1302.Then remove H.V. CBA (with Holder).CAUTION 2: Electrostatic breakdown of the laserdiode in the optical system block may occur as apotential difference caused by electrostatic chargeaccumulated on cloth, human body etc., duringunpacking or repair work.To avoid damage of pickup follow next procedures.2-1. Slide the pickup unit as shown in Fig. 5.2-2. Short either of the two type three short lands withsolder before removing the FFC cable (CN101)from it. If you disconnect the FFC cable (CN101),the laser diode of pickup will be destroyed. (Fig.5)2-3. Disconnect Connector (CN401). Remove screws3(S-7) and lift the DVD Main CBA Unit. (Fig. 5)CAUTION 3: When reassembling, confirm the FFCcable (CN101) is connected completely. Then removethe solder from the three short lands. (Fig. 5)4. Remove screws 7(S-10) and 2(S-11). Then, desol-der connectors (CL1201, CL1401, CL1402,CL1403) and lift up the Deck Assembly.