Magnavox 27MS5402 Quick Use And Setup Manual

Also see for 27MS5402 - 27v 100hz Tv: User manual Product specifications Product specifications

Magnavox 27MS5402 Quick Use And Setup Manual Manual pdf 1 page image

3121 233 45891Important Notice/Warning . . . . . . . . . . . . . . . . . . . . .1Basic TV Operation . . . . . . . . . . . . . . . . . . . . . . . . . .1Remote Battery Installation . . . . . . . . . . . . . . . . . . .1Remote Control Button Descriptions . . . . . . . . . . . .1Hooking up the TelevisionBasic Cable/Cable Box TV Connections . . . . . . . . .2Basic Antenna TV Connections . . . . . . . . . . . . . . . .2AV1 Input Connections . . . . . . . . . . . . . . . . . . . . . .3AV2 Input Connections . . . . . . . . . . . . . . . . . . . . . .3S-Video Input Connection . . . . . . . . . . . . . . . . . . . .3Component Video Input Connections . . . . . . . . . . .3AV4 Input Connection . . . . . . . . . . . . . . . . . . . . . . .4Monitor Output Connections . . . . . . . . . . . . . . . . . .4Side (AV3) Audio/Video Input Connection . . . . . . .4CONTENTSB ASIC TV AND REMOTE OPERATIONYour television has a set of controls located on the top and frontof the cabinet for use when the remote control is not needed.1 Press the POWER button on the front of the TV cabinet to turnthe TV ON.Note: With AutoChron ON, the TV will search for a PBS chan-nel to set the clock before powering itself on. This can take sev-eral seconds.2 Press the VOLUME + button to increase the sound level or theVOLUME - button to lower the sound level.Pressing both buttons at the same time will display theonscreen menu. After you are in the menu, use the Volume + or -buttons to make adjustments or selections.3 Press the CHANNEL + (Up) or - (DOWN) button to selectTV channels. Use these buttons to make adjustments or selec-tions in the onscreen menu.There is also a set of Audio and Video Input jacks located on the side ofthe television cabinet. Refer to the Side AV3 Input section on page 4 ofthis Quick Use and Hookup Guide.TELEVISIONPOWER3+ –VOLUME + –CHANNEL21 Remote SensorWindowAudio, Video, S-Videoand Headphone Jackslocated on the side ofthe television.Volume and Channel buttons are locatedon the top of the television cabinet.T o load the supplied batteries into the remote:1 Remove the battery compartment door on the back ofthe remote.2 Place the batteries (2-AA) in the remote. Make sure the (+)and (–) ends of the batteries line up correctly (the inside ofthe case is marked).3 Reattach the battery compartment door.Be sure to point the remote at the Remote Sensor window on thefront of the television when using it to operate the television.REMOTE CONTROL B ATTERIESREMOTE CONTROL B UTTONSQuick Use and Setup GuideQuick-Use and Setup GuideIMPORTANTNOTE: This owner's manual is used with severaldifferent television models. Not all features (anddrawings) discussed in this manual will necessar-ily match those found with your television set.This is normal and does not require you contact-ing your dealer or requesting service.WARNING: TO PREVENT FIRE OR SHOCKHAZARD DO NOT EXPOSE THIS UNIT TORAIN OR EXCESSIVE MOISTURE.ColorTelevisionColorTelevisionBatteryCompartmentLidPOWERSLEEPA/CH STATUS/EXIT CC CLOCKRECORDTVVCRACCSMART SMARTSMARTSOUND PICTUREMENU SURFVOL CHMUTE1 2 34 5 67 8 90TV/VCRPOWER ButtonPress to turn the TV or accessory devices on or off.CC ButtonPress to select Closed Captions. Refer to the Owner’s Manual fordetails.CLOCK • TV/VCR ButtonIn TV mode, press to see the Clock menu.In VCR mode, press to put the VCR in TV or VCR position. Use VCRposition to watch tapes. Use TV position to view one TV channel whilerecording another.Number ButtonsPress to select TV channels. When selecting single-digit channels, pressthe number of the desired channel. The TV will pause for a few seconds,then tune to the selected channel. For quicker results, press "0," then thenumber. For channels 100 and above, first press "1," then the next twonumbers of the channel.SMARTPICTURE™ ButtonPress to select a SmartPicture setting. These are preset picture controlsfor different types of viewing sources and programs.SURF/FF (pause) ButtonIn TV mode, press to select previous channels. You can place up to eightchannels in memory, then press SURF to quickly scan those channels. Seethe owner's manual for details.In VCR mode, press this button to pause a videotape.CHANNEL +/– ButtonsPress to change channels.SLEEP ButtonPress to set the TV to turn itself off. It also can be used as anEnter button when sending channel commands to CableConverter Boxes or VCRs.STATUS/EXIT ButtonPress to see the current channel number on the TV screen. Press toclear the TV screen after control adjustments.A/CH • RECORD ButtonPress to toggle between the current channel and the previous chan-nel. In VCR mode, press to start recording.TV/VCR/ACC Mode SwitchSet to TV to control TV functions, VCR to control VCR functions, andACC for a Cable Converter, DBS, DVD Player, etc.SMARTSOUND™ ButtonPress to select a SmartSound control. These are preset soundcontrols for different types of programming.MENU ButtonPress to access or remove the on-screen menu., , and ■ ButtonsUse these buttons to select and adjust menu items. Use with aVCR for PLAY, FAST FORWARD, REWIND, and STOP.VOLUME +/– ButtonsPress to adjust the TV sound level.MUTE ButtonPress to turn off the TV sound. Press again to return the sound toits previous level.

/ 4

Related manuals for Magnavox 27MS5402 - 27v 100hz Tv