Magnavox 32MD251D User Manual

Also see for 26MD251D - 26" Lcd Hd Flat Tv: Specifications Getting started guide Specifications Software guide Supplementary guide

Magnavox 32MD251D User Manual Manual pdf 14 page image

14InstallationSelect Autoprogram in the Installation menu.Use the cursor right to enter the Autoprogram menu.Press the OK button.Select Cable or Antenna in the Installation mode.When Antenna is selected, the TV will detect antennasignals and will search for antenna TV (NTSC and ATSC) channelsavailable in your local area.When Cable is selected, the TV will detect cable companysupplied signal sand will search for cable TV (NTSC, ATSC, QAMmodulated) channels available in your area.Make sure that registration with your cable TV provider andconnection of equipment are completed.Press the green button “Next” on the remote control.Note: All channels must be unlocked in order to autoprogram. Ifrequested, enter your PIN code to unlock all channels. See Menupreferences in the Settings, TV menu, p. 18.Press the green button “Start” to start autoprogramming. Themenu screen disappears and the progress of autoprogramming isdisplayed. The progress bar indicates the number of analog anddigital TV channels found.When Autoprogramming is complete, a message appearsconfirming the completion and the TV switches to the firstinstalled TV channel.SettingsSetupExitInfoInstallationLanguageAutoprogramWeak channel installationSoftware upgradeTVInstallationSettingsInstallationInfoAutoprogramStart nowLanguageAutoprogramWeak channel installationSoftware upgradeTelevision InstallationInstallation modePrevious NextAntenna Please select yourinstallation modeCableNotes:• When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code inorder to complete Autoprogramming.• ATSC channel information is updated automatically when the TV is in standby after 3 minutes and every 3 hours thereafter.• When channel update is interrupted, the new updated channel information is retained along with the old un-updatedchannel information.• Background Autoprogramming occurs only when the TV is turned on.• Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.• If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequenciesand update information.• Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thusoptimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 15.)• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.• If Antenna/cable signal is interrupted more than ten minutes, TV will go into off mode. You are requested to press Power buttonor CH / button to turn on the TV.Select the menu languagePress the MENU button on the remote control.Use the cursor down to select Installation in the Settings menu.Use the cursor right to enter the Installation menu.Select Language and enter the list of available languages with thecursor right.Select your preferred language with the cursor up/down and pressthe OK button to confirm you selection.Proceed with the Installation menu.Store TV channels123456123456