17 English4 Use your TVSwitching on your TV and putting it inStandby modeTo Turn the TV On from Standby or Off to Standby• Press (3 raised dots on the Rear panel) or Front panel or theRemote control.Adjusting volumeTo decrease or increase volume• Press VOL ◄ / ► (1 raised dot on the Rear panel) or Front panelor press VOL + / − on the Remote control.VOL ◄ : Volume DownVOL ► : Volume UpTo mute or unmute sound• Press on the remote control to mute the sound.• Press again or VOL + / − to recover the original sound.Switching channelsTo select Channels by using CH ▼/▲ or CH + / −• Press CH ▼ (Down) / ▲ (Up - 1 raised dot on the Rear panel) orFront panel or press CH + / − on the Remote control.To select Channels by using the NUMBER buttons• For Digital channels, press a number followed by a dot “•” and thecorresponding sub channel number.– When selecting Digital channel 11.1Be sure to press • before entering the subchannel number.– When selecting cable or Analog channel 11Press PREV.CH to return to the previously viewed channel.* On the 46” & 50” TV’s All CONTROL Keys are located on the Rear(lower right) side of the unit as viewed from the Front.Note• Energy consumption contributes to air and water pollution. When the AC power cordis plugged in, your TV consumes energy. Your TV has very low standby powerconsumption.50ME313V / 46ME313V40ME313V / 39ME313V / 39ME413V /32ME303V / 32ME403V / 29ME403V /24ME403V* Key on Rear50” - 39” 32” - 24”50ME313V / 46ME313V40ME313V / 39ME313V / 39ME413V /32ME303V / 32ME403V / 29ME403V /24ME403V* Keys on RearNote• To select the non-memorized channels, use the NUMBER buttons.• No Signal will appear on the TV screen after the subchannel broadcast is over.• Audio only program message will appear on the TV screen, when you receive onlysound signal.50” - 39” 32” - 24”50ME313V / 46ME313V40ME313V / 39ME313V / 39ME413V /32ME303V / 32ME403V / 29ME403V /24ME403V* Keys on RearDigital TV operationAnalog/Cable TV operation