Magnavox 42MD459B User Manual

Also see for 42MD459B - 42" LCD TV: User manual Specification Quick start guide

Magnavox 42MD459B User Manual Manual pdf 18 page image

[] Channel SelectionSelectchannelsbyusing[OH-t-/ -] or [the Numberbuttons].• To select the memorized channels, use [CH + I -] or[the Number buttons].• To select the non-memorized channels, use[the Number buttons].To Use [the Number buttons]17[Volume AdjustmentThissectiondescribeshow to adjustthe volume.Themutefunction,whichturnsthe soundoffand on, isalsodescribed.Use [VOL + I -] to adjust the audio volume.When selecting analog channel 11When selecting digital channel 11.1Be sure to press [.] beforeentering the subchannel number.• Press [PREV CH] to return to the previously viewedchannel.About digital TV broadcasting:With its high definition broadcast, digital broadcastingfar surpasses analog broadcasting in both its pictureand sound quality. Not all digital TV broadcasts are highdefinition (HD). To confirm whether your watching TVprogram is in HD, refer to the program guide, contactyour cable / satellite provider or local TV stations.NTSC _ ATSC(analog mode) (digital mode)6:00pro6:3oprn7:00pro.............7:30prn8:00pmWhat is the subchannel?By using high compression technology, digitalbroadcasting offers a service that enables multiplesignals to send simultaneously.Therefore, you can select more than one program permain channel since digital broadcasting technologydistinguishes between multiple channels broadcast bya single network.can be changed by using [CH + I -].Note:• "No Signal" will appear on the TVscreen after thesubchannel broadcast is over.• "Audio onlyprogram" message will appear on the TVscreen, when you receive only sound signal.The volume bar will be displayed at the bottom of the-IV screen when adjusting the volume.• The volume bar will automatically disappear in a fewseconds.Press [MUTE] to turn off and on the sound.MUTE"Mute" is displayed on the TV screen for a few seconds.Press [MUTE] again or [VOL + I -] to recover theoriginal volume.I-V[Sleep TimerThesleeptimer canbesetto automaticallyturnoff the unit afteranincrementalperiodof time.Press [SLEEP] to set the sleep timer.SLEEPSleep timer display appears on the -IV screen.2 Press [SLEEP] repeatedly to change the amount of timeuntil shut off.SLEEPYou can set your unit to turn off after a set period oftime (from 30 to 120 minutes).• Each press of [SLEEP] will increase the time by 30minutes.• After setup, the sleep timer display can be called upfor checking by pressing [SLEEP].To cancel the sleep timerPress [SLEEP] repeatedly until "Sleep Off" is displayedon the -IV screen.Note:• The sleep timer display will automatically disappear in afew seconds.• When you disconnect the unit from the AC outlet or whena power failure occurs, the sleep timer setting will becanceled.EN