16ENWATCHING TVStill ModeYou can pause the image shown on the TV screen.Press [FREEZE] to pause the image shown on the TVscreen.FREEZEThe sound output will not be paused.If no signal is detected or protected signal is receivedduring still mode, the image remains paused and thesound output will be muted.The still function will be released after 5 minutes.To cancel still mode, press any button except[yy(power)].Switching Each Input ModeYou can easily switch with the remote control to the DTV (ATSC) and TV(NTSC) or to access external devices when they are connected to the unit.Press [SOURCE] or [CH +] repeatedly to cycle throughthe input modes.Video1Input SelectTVVideo1Video2ComponentHDMI1HDMI2HDMI3Video2ComponentHDMI1HDMI2HDMI3DTV/TV channel(or PC input)Pressing [CH ] reverses the direction of the inputmodes.5•••5•Switching Audio ModeThis section describes how to switch the audio in the analog mode and howto switch the audio language in the digital mode.TVPress [SAP] to display the currently selected audiomode. While receiving an MTS broadcast, pressrepeatedly to cycle through the available audiochannel.11SAP / STEREOWhen all audio are availableSAP / STEREO SAP / MONOSAP / STEREOWhen stereo and monaural audio are availableMONO / STEREO MONO / STEREOWhen SAP and monaural audio are availableSAP / MONO SAP / MONOWhen only monaural audio is availableMONOSTEREO : Outputs stereo-audioSAP : Outputs second audio programMONO : Outputs mono-audioDTV1 Press [SAP] to display the currently selected languageand the number of available languages.11.1English 1/32 Press [SAP] repeatedly to cycle through the availableaudio languages.Available languages differ depending on thebroadcast. “Other” is displayed when the audiolanguage cannot be acquired, or the acquiredlanguages are other than English, Spanish or French.Note:• [SAP] does not control external audio devices.• The information display will automatically disappear in afew seconds.5•(cannot be switched)