Magnavox 46MF460B Owner's Manual

Supplied AccessoriesOwner's manual Quick Start(1EPIN26819) (1 EPIN25860)Remote control Registration card(NFd04UD) (1EHN25026)AC power cord(WAV0t 62LW001) or(WAV0162LTE03) or(WAV152ZH N00t )Batteries Screw kit(AAA, 1.SV x 2) for attaching the base(1 ESA2436S)If you need to replace these accessories, please referto the part No. with the illustrations and call our toilfree customer support line found on the cover of thismanual.Note• If you lose the screws, please purchase HSx12 Phillips head screws at yourlocal store,Attaching the BaseYou must attach the base to the unit to have it as a table topunit. Be sure the front and rear of the base match the properdirection.23Spread a thick and softcloth over a table asshown.Place the main unit faceup onto it. Make sure notto damage the screen, Atleast 2_people are requiredfor this step,Insert 2_hooks under thebottom of the main unitinto base holes, (shown byarrow (_)), then move thebase in the direction asshown by arrow @ until itstops and the 6 mountingholes are aligned.Drive Phillips head screwsinto the 6 threaded holesat the bottom of the baseuntil they are tight.To remove the base from ths unt• Unscrew the Phillips head screws on step 3.After the screws are removed, move tlne base in the opposite direction asslnown by arrow (2) on step 2, then pull tlne base up toward the front of theunit. Be careful not to drop the base when you remove it.Note• When attaclning the base, ensure that all screws are tightly fastened. Iftlnebase is not properly attached, it could cause the unit to fall, resulting ininjuries as well as damage to the unit.• Make sure to use a table which can support the weight of this unit and islarger tlqan tNs unit.• Make sure tlne table is in a stable location,• When attaching the base, ensure that FRONT t written on the base isupward, if it's not upward, the 2 hooks don't fit in the base,Symbols Used in this ManualThe following is the description for the symbols used inthis manual. Description refers to:: DigitalTV operation: Analog/Cable TV operation• If neither symbol appears, the operation is applicabie toboth.Fixing the Unit on Your FurnitureScrew this unit on your furniture tightly using wood screws(not supplied) in the 2 holes atthe bad< of the base as shown.• Recommended screw dimension : 5,1 × 20 mmrear of this unitholesNote• Wlqen you remove this unit make sure to unscrew the wood screws fi_omyourWood Stand, Furn ture and other wood tenn.6EN