Magnavox MBP6700P Owner's Manual

Contents

Magnavox MBP6700P Owner's Manual Manual pdf 41 page image

EN4110. SETUPS10.1. Network connection[HOME] A “Setup” A “Network” A “Network installation”Perform the network connection setup in order to use network features, such as BD-Live™ and the network update function.C Connection testAfter you enable a network connection or change network settings, always perform the connection test to check to see if the con-nection is correctly made.1. Press [HOME] and use [ ] to select “Setup” in the home menu, then press [OK].2. Use [ ] to select “Network”, then press [OK].3. Use [ ] to select “Network installation”, then press [OK].4. Use [ ] to select “Connection Test”, then press [OK].• Connection test will automatically start. The test result will appear right after the test finishes.5. After the test results display, press [OK].NoteD• If the connection test passes, you are ready to use BD-Live™ and the network update function, using the Internet without makingany additional settings.• If the connection test fails, you may need to check your router settings and make sure the physical connection is secure. If youneed the MAC address of this unit to complete your Router settings, you can view it in “View network settings”.• When connecting this unit directly to a modem for the first time or connecting it to a modem which was previously connectedto any other network device (e.g. a Router, PC, etc.), you may have to power cycle the modem (unplug the modem’s and/orrouter’s AC power cord from its AC outlet for 30 seconds and then plug it back in), this may reset the settings in the modem. Ifyou have a telephone/internet modem with your cable service then you may have to use its reset button or remove the backupbattery to reset this type of modem.• If the connection test fails, this unit is not connected to the Internet. In this case, you cannot use the BD-Live™ and networkupdate function. Please confirm router settings or contact your ISP (Internet Service Provider) for troubleshooting assistance.C Network configurationAuto setupIn order to make a wired connection, connect an ethernet cable from a router with internet access. A network will automatically beestablished.• In order to confirm that this unit is connected to the Internet, perform “Connection test” (refer to page 41).1. Connect an ethernet cable from a router with internet access.2. Press [HOME] and use [ ] to select “Setup” in the home menu, then press [OK].3. Use [ ] to select “Network”, then press [OK].4. Use [ ] to select “Network installation”, then press [OK].5. Use [ ] to select “Start”, then press [OK].6. Use [ ] to select “Auto setup”, then press [OK].• Network setting will automatically be performed.continued on next page