Magnetek Flex 4EX2 Instruction Manual

Contents

Magnetek Flex 4EX2 Instruction Manual Manual pdf 20 page image

Flex 4EX2 / 6EX2 MRX CE Instruction ManualNovember 2018Page 20 of 444.1.3 Remote PairingA. Transmitter-to-Transmitter Pairing:1. Rotate the power switch key to OFF ( 0 ) position.2. With the STOP button elevated, press and hold PB1 and PB3at the same time.3. Rotate the power switch key to ON ( I ) position.4. Release PB1 and PB3 at the same time. The system will enterRemote Pairing mode. The Status LED displays firmwareversion with red, green and orange blinks.5. Output data (original transmitter) by pressing and holding PB2(Status LED off).6. Receive data (new transmitter) by pressing and holding PB1 (Status LED blinksgreen).7. When the Status LED (receiving data end) turns to solid green while both pushbuttonsare still pressed down, the pairing is completed.8. Exit Remote Pairing mode by rotating the power switch key to OFF ( 0 ) position.NOTE: During remote pairing make sure the distance between the two transmittersis no more than 1 meter.→Output data – original transmitter Receive data – new transmitter(press and hold PB2) (press and hold PB1)