Magnetek Flex 8RS System Instruction Manual

Magnetek Flex 8RS System Instruction Manual Manual pdf 17 page image

Flex 8RS System Instruction ManualDecember 201214 of 364.1.2 Push Button Functions – SetupWARNINGTHE TRANSMITTERS ARE UNIQUE AND FACTORY PRESET. DO NOT CHANGE THE TRANSMITTER SETTINGSUNLESS YOU ARE REPLACING AN EXISTING TRANSMITTER. CHANGING THE SETTINGS COULD MAKE ITCOMMON WITH ANOTHER TRANSMITTER, WHICH COULD MOVE OTHER EQUIPMENT. WRONG TRANSMITTERSETTINGS MAY CAUSE EQUIPMENT TO OPERATE IMPROPERLY. FAILURE TO FOLLOW THIS WARNING COULDRESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO EQUIPMENT.NOTE: All settings are pre-set at the factory. The following information is to be used for setting upreplacement transmitters only.NOTE: For all system types, the transmitter function dipswitch 7 selects operation of the system ininterlock and non-interlock modes.When interlock mode is selected (dipswitch 7 is on/up), only 1 receiver can be selected at a time.When non-interlock mode is selected (dipswitch 7 is off/down), all receivers can be selected at the sametime.4.1.2.1 Type “B” Transmitter Setup and ConfigurationPush ButtonRS SystemTYPE BSettingA/B Receiver Selectwith Bridge ReceiverON CTS1 2 3 4 5 6 7 8FUNCTION DIP_SWTYPE BA,B,C,D interlock/non-interlockTransmitterS/N: XXXXXXTYPE:01ABCDB AReceiver AReceiver BS/N:XXXXXXTYPE:01S/N:XXXXXXTYPE:02Bridge RXS/N:XXXXXXTYPE:00JP4: ShortedJP5: Shorted*UP (1): interlock, Down (0): non-Interlock*When receiver is selected,relays respond to TX buttons1, 2, 3 and 4Refer to Relay Chart #1*When receiver is selected,relays respond to TX buttons1, 2, 3 and 4Refer to Relay Chart #1*Receiver is always selected.Relays respond to TX buttons5 and 6Refer to Relay Chart #2