Magtek ExpressCard 2000 Replacement Manual
Also see for ExpressCard 2000: ManualReplacement procedureUser's installation and operation manualManualPreventive Maintenance Procedure
             | |
3 - XY Transport Ribbon Cable Replacement ProcedureExpressCard 2000| Instant Issuance Card Personalization System | XY Transport Ribbon Cable Replacement ProcedurePage 83.2 Remove / Re-install the XY Transport Ribbon CableThis section provides information for replacing just the XY transport ribbon cable, which occasionallymust be replaced without replacing the entire module. For instructions on removing and re-installing theentire XY transport module, see 99875607 ExpressCard 2000 Hardware Service Manual or33070932 ExpressCard 2000 XY Transport Module Replacement Procedure.Figure 3-1 - XY Transport Showing Ribbon Cable (FRONT VIEW)To remove the XY transport module’s ribbon cable, follow these steps:1) Open the top access door (see 99875607 ExpressCard 2000 Hardware Service Manual).2) Move the XY transport to the front of the device to expose its cable and its connection to the circuitboard (“breakout board”) on the base plate of the device (see Figure 3-2 and see 99875607ExpressCard 2000 Hardware Service Manual for details). |
Related manuals for Magtek ExpressCard 2000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine