Tranquility Stones KitInstallation InstructionsModel: TQS36for use on Gas Fireplace Models:DVBR36RN* (GFCN3J0)* The Tranquility Stones may also be used if the unit is converted to propaneCAUTION: This kit is designed for use onthe above gas fireplace models ONLY.CAUTION: This kit must be installed by aqualified service technician.Read the instructions carefully before beginningthe installation.CAUTION: Allow the unit to cool complete-ly if it has been in operation.Kit contents: Stone tray, stones (30), ceramic overlay,hardware package, installation instructions.Check the contents of the carton with contents list. Ifany parts are missing or damaged, contact your dealer.Turn OFF gas supply and electric supply to the unitbefore beginning.Installation Instructions1. Remove valve cover. (Fig. 1)2. Release the two (2) clamps at the bottom of thewindow frame by pulling back on the clamp handles.(Fig. 2)3. Lift off the glass frame. (Fig. 2)4. Remove the logs and any ember material from thefireplace. Discard logs and ember material.5. Remove the two (2) screws securing the grate. Re-move the grate and reinstall the two (2) screws. (Fig.3) Discard grate.C USH100hearth Panels3/15/99 djtGrateScrewBurner ScrewHearth PanelsFront of Fireplace H100Fig. 1 Remove grate.G584-500Valve CoverPinsLocating HolesValveG584-500Fig. 1 Remove valve cover.G584-501Remove glass frame2/99 djtClampsGlassFrame FireplaceFrontGlassPanelPullClampHookGlassPanelG584-501Fig. 2 Remove glass frame.6. If there is any lava rock on the hearth panels,remove and set aside. Remove and discard hearthpanels.7. Install the stone tray in the fireplace. The two (2)small holes on the right side back of the assembly fitover the two (2) studs on the rear log support. (Figs.4 & 5)8. Secure the stone tray in position with the two (2)nuts and one (1) screw provided. (Fig. 5)9. Replace any lava rock removed from the fireplace.20012963 3/08 Rev. 2