Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Make Mendel RapidBot Mega User Information

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Contents
  1. Heated Print
  2. Smooth Rod
  3. Flange
  4. Table Of Contents
  5. Table Of Contents
  6. Extruder
  7. M4x40 Socket,
  8. Belt
  9. Print
Make Mendel RapidBot Mega User Information Manual pdf 25 page image
MAKE MENDEL Page 25Steps to be followed while using Printrboard Electronics:1. Check whether all the connections made on your Printrboard Board are proper.2. Printrboard comes ready to print with Marlin RC 2 Firmware and LUFA CDCBootLoader, So you do not need to change any firmware, if you have purchased entireRapidbot 3.0/Mega Kit from us.3. Install Pronterface (With Slic3r) http://makemendel.com/support-1/downloads4. Set Baud rate as 2500005. Note: You have to connect the Hotend thermister to PrintrBoard, then this“MinTemprature triggered” error will go away.6. Remove the Boot Loader(Black) Jumper from the printrBoard, before connecting itto the PC. The jumper is only needed only during the firmware update.Printer Images :Front View
/ 27
Related manuals for Make Mendel RapidBot Mega
Make Mendel MegaBot Manual first page preview
Make Mendel MegaBot Manual
Make Mendel PlusBot Manual first page preview
Make Mendel PlusBot Manual
This manual is suitable for:
RapidBot Mega
Manuals database logo
manualsdatabase
Your AI-powered manual search engine