19The Shift Function trades the values for the Variable Clock Outputs and is accessed from the Program Edit page (Double PressPGM_B).For example, if Channels 2, 3, and 5 are set to be Shifted, the Variable Clock value at Channel 2 is swapped with the Variable Clockvalue at Channel 5 at the Rising Edge of the Gate patched to the Mod Input, simultaneously replacing the value of Variable Clock 3with that of the previous Variable Clock 2, allowing Channel 5 to take on the original value of Channel 3…. In other words, itbehaves as a Shift Register for the Variable Clock parameter values, where at each Shift command received, the values are passedto the next active Mod Enabled Channel. These changes always occur at the Rising Edge of the signal patched to the Mod Input sothat when a Gate High is read, the Mod LED flashes Magenta and the Shift occurs immediately, allowing for an TEMPI Channelpatched to the Mod Input to control the Variable Clocks Shifts.Program Edit: ShiftUsing Button-4 on the Program Edit Page, Shift may be Programmed to operate in the following directions:Clockwise, CWButton-4 = RedCounterclockwise, CCWButton-4 = BlueRandom (aka RODENT Mode)Button-4 = PurpleTypes of Shift and Reset:There are (2) Types of Shift behaviors, Programmed using Button-6 on the Program Edit Page:• Not-Jumbled Shift is the Default and recalls the last stored settings when navigating away and back to State; Button-6 = OFF• Jumbled Shift recalls to the values last utilized at that State when navigating away and back to a State; Button-6 = RedDisengage Jumbled Shift when you want to easily return to a State’s Programmed Variable Clocks after Shifting Channels.Note: Muted Channels are not Shifted. One could emulate a Shifted Mute by Programming a large Division and Shifting.If both Shift and Run/Stop are both enabled (See Page 21), all State selection must be done using the State Select CV andCombo Pot.Tip: Shift is also useful for Programming variations of States where you want use the same Channels:1. Create your initial State.2. Copy and then Paste to another State.3. Press PGM_B to enter the Mod Programming Page and set two Channels to be Shift Enabled, Purple.4. Send a Gate signal to the Mod Input to swap their Variable Clock values.5. Set these two Channels back to being Mod disabled.Use this technique to trade Variable Clock values and create new States.Shift = OffButton-5 = OffRun/Stop and ShiftButton-4 and 5 = RedNew to v.31