Makita 1806B Instruction Manual

Also see for 1806B: Instruction manual Parts Breakdown Instruction manual Instruction manual Instruction manual

Contents

410. Keep at least 200 mm (8”) away from the tool atall times.11. Always switch off and wait for the blades tocome to a complete stop before any adjusting.12. Never stick your finger into the chip chute.Chute may jam when cutting damp wood. Cleanout chips with a stick.13. Do not leave the tool running. Operate the toolonly when hand-held.14. When leaving the planer, switch off and set itwith the front base up on a wooden block, sothat the blades do not contact anything.15. Always change both blades or covers on thedrum, otherwise the resulting imbalance willcause vibration and shorten tool life.16. Wait for complete run-down before putting thetool aside.17. Use only Makita blades specified in this manual.18. Some material contains chemicals which may betoxic. Take caution to prevent dust inhalationand skin contact. Follow material supplier safetydata.SAVE THESE INSTRUCTIONSWARNING:MISUSE or failure to follow the safetyrules stated in this instruction manualmay cause serious personal injury.SYMBOLSUSD201-2The followings show the symbols used for tool.V............................voltsA ...........................amperesHz..........................hertz....................alternating current.......................no load speed.......................Class II Construction.../min....................revolutions or reciprocation perminuteFUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting depth of cutDepth of cut may be adjusted by simply turning the knobon the front of the tool.Switch actionCAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly and returnsto the “OFF” position when released.• Switch can be locked in “ON” position for ease ofoperator comfort during extended use. Apply cau-tion when locking tool in “ON” position and maintainfirm grasp on tool.To start the tool, simply pull the switch trigger. Releasethe switch trigger to stop.For continuous operation, pull the switch trigger and thenpush in the lock button.To stop the tool from the locked position, pull the switchtrigger fully, then release it.ASSEMBLYCAUTION:• Always be sure that the tool is switched off andunplugged before carrying out any work on the tool.Removing or installing planer bladesCAUTION:• Tighten the blade installation bolts carefully whenattaching the blades to the tool. A loose installationbolt can be dangerous. Always check to see theyare tightened securely.1. Knob1. Lock button2. Switch trigger100256312002552