Makita 2012NB Instruction Manual

Also see for 2012NB: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

7Dimensional adjustmentLower the main frame by turning the crank handle counter-clockwise until the indicator plate points to the scale gradua-tion indicating the desired finished dimension. One full turn ofthe crank handle moves the main frame 2 mm (3/32”) up ordown. The scale has inch graduations on its right side andmetric graduations on its left side.Adjusting depth of cutThe maximum depth of cut differs depending upon the widthof workpiece being cut. Refer to the table. When you need toremove more than the amount specified in the table, set thedepth of cut shallower than the amount and make two ormore passes.To adjust the depth of cut, proceed as follows.Insert the workpiece flat on the table top. Lower the mainframe by turning the crank handle counterclockwise. Thedepth gauge will rise and the amount of gauge rise indicatesthe depth of cut.CAUTION:• Always lower the main frame when aligning the indicatorplate with the graduation indicating the desired finisheddimension. If you raise the main frame into the desiredfinished dimension, additional play in the screw mayresult. This may cause an undesired finished dimension.• Always place the workpiece flat on the table top whenpredetermining the depth of cut. Otherwise, thepredetermined depth of cut will differ from actual depthof cut.1. Crank handle2. Scale3. Indicator plate4. Main frame1234003710Width of workpiece being cutLess than 150 mm (5-7/8”)150 mm (5-7/8”) - 240 mm (9-1/2”)240 mm (9-1/2”) - 304 mm (12”)Maximum depth of cut3.0 mm (1/8”)1.5 mm (1/16”)1.0 mm (3/64”)0037111. Depth gauge1003712

/ 20

Related manuals for Makita 2012NB

Makita 2012NB Instruction Manual

Makita 2012NB/2 Instruction Manual

This manual is suitable for:

2012NB

manualsdatabase

Your AI-powered manual search engine