Makita 2414NB Instruction Manual

Also see for 2414NB: Technical information Instruction manual Instruction manual Instruction manual Instruction manual

Contents

311. ALWAYS USE SAFETY GLASSES. Alsouse face or dust mask if cutting operationis dusty. Everyday eyeglasses only haveimpact resistant lenses, they are NOTsafety glasses.12. SECURE WORK. Use clamps or a vise tohold work when practical. It’s safer thanusing your hand and it frees both handsto operate tool.13. DON’T OVERREACH. Keep proper footingand balance at all times.14. MAINTAIN TOOLS WITH CARE. Keep toolssharp and clean for best and safest perfor-mance. Follow instructions for lubricatingand changing accessories.15. DISCONNECT TOOLS before servicing;when changing accessories such asblades, bits, cutters, and the like.16. REDUCE THE RISK OF UNINTENTIONALSTARTING. Make sure switch is in offposition before plugging in.17. USE RECOMMENDED ACCESSORIES.Consult the owner’s manual for recom-mended accessories. The use of improperaccessories may cause risk of injury topersons.18. NEVER STAND ON TOOL. Serious injurycould occur if the tool is tipped or if thecutting tool is unintentionally contacted.19. CHECK DAMAGED PARTS. Before furtheruse of the tool, a guard or other part thatis damaged should be carefully checkedto determine that it will operate properlyand perform its intended function - checkfor alignment of moving parts, binding ofmoving parts, breakage of parts, mount-ing, and any other conditions that mayaffect its operation. A guard or other partthat is damaged should be properlyrepaired or replaced.20. DIRECTION OF FEED. Feed work into ablade or cutter against the direction ofrotation of the blade or cutter only.21. NEVER LEAVE TOOL RUNNING UNAT-TENDED. TURN POWER OFF. Don’t leavetool until it comes to a complete stop.22. REPLACEMENT PARTS. When servicinguse only identical replacement parts.23. POLARIZED PLUGS. To reduce the risk ofelectric shock, this equipment has apolarized plug (one blade is wider thanthe other). This plug will fit in a polarizedoutlet only one way. If the plug does not fitfully in the outlet, reverse the plug. If itstill does not fit, contact a qualified elec-trician to install the proper outlet. Do notchange the plug in any way.VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet,etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool.A power source with voltage greater than that specified for the tool can result in SERIOUSINJURY to the user - as well as damage to the tool. If in doubt, DO NOT PLUG IN THETOOL. Using a power source with voltage less than the nameplate rating is harmful to themotor.