Makita 2414NB Instruction Manual

Also see for 2414NB: Technical information Instruction manual Instruction manual Instruction manual Instruction manual

Contents

411. Before using the tool on an actual workpiece,let it simply run for several minutes first.Watch for flutter or excessive vibration thatmight be caused by poor installation or apoorly balanced wheel.12. Watch out for flying sparks when operating.They can cause injury or ignite combustiblematerials.13. Remove material or debris from the area thatmight be ignited by sparks. Be sure that othersare not in the path of the sparks. Keep a proper,charged fire extinguisher closely available.14. Use the cutting edge of the wheel only. Neveruse side surface.15. If the wheel stops during the operation, makesan odd noise or begins to vibrate, switch offthe tool immediately.16. Always switch off and wait for the wheel tocome to a complete stop before removing,securing workpiece, working vise, changingwork position, angle or the wheel itself.17. Do not touch the workpiece immediately afteroperation; it is extremely hot and could burnyour skin.18. Store wheels in a dry location only.SAVE THESE INSTRUCTIONS.INSTALLATIONSecuring cut-off12003800This tool should be bolted with two bolts to a level andstable surface using the bolt holes provided in the tool'sbase. This will help prevent tipping and possiblepersonal injury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Switch action12005269CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.For tool with lock buttonTo start the tool, simply pull the switch trigger. Releasethe switch trigger to stop. For continuous operation, pullthe switch trigger and then push in the lock button. Tostop the tool from the locked position, pull the switchtrigger fully, then release it.For tool with lock-off buttonTo prevent the switch trigger from being accidentallypulled, a lock-off button is provided.To start the tool, depress the lock-off button and pull theswitch trigger. Release the switch trigger to stop.Spark guard12003756The spark guard is factory-installed with its lower edgecontacting the base. Operating the tool in this positionwill cause many sparks to fly around. Loosen the screwand adjust the spark guard to a position at whichminimum sparks will fly around.1. Screw2. Spark guard1. Lock button /Lock-off button2. Switch trigger1. Base2. Bolt holes