Makita 2702X1 Instruction Manual

Also see for 2702: Parts manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

14Push stickA push stick can be easily made from a piece of ply-wood 19 mm (3/4”) to 25 mm (1”) thick.Cut out the hatched area on the stick and smoothedges with a file. (H) dimension should be less than12.7 mm (1/2”) so as to be thinner than the workpiece.Push blockUse a 19 mm (3/4”) piece of plywood.Handle should be in center of plywood piece. Fastenwith glue and wood screws as shown. Small piece 9.5mm x 8 mm x 50 mm (3/8” x 5/16” x 2”) of wood mustalways be glued to plywood to keep the blade fromdulling if the operator cuts into push block by mistake.(Never use nails in push block.)Auxiliary fenceMake auxiliary fence from 9.5 mm (3/8”) and 19 mm(3/4”) plywood pieces.300 mm (12”)120 mm(4-3/4”)16 mm (1/4”) 50mm (2”)130 mm(5”)250 mm(2”)130 mm(5”)350 mm (2”) 8 mm (5/16”)49.5 mm (3/8”) 100 mm (4”)300 mm (12”)(H) 9.5 mm(3/8”)130 mm (5”)75 mm (3”)9.5 mm (3/8”) 50 mm(2”)19 mm(3/4”)40 mm(1-1/2”) 50mm (2”)380 mm (15”)1. Face/edge parallel2. Handle3. Wood screw4. Glue together9.5 mm(3/8”)120 mm(4-3/4”)119 mm(3/4”)40 mm(1-1/2”)460 mm (18”) 140 mm(5-1/2”)Fasten with glue and wood screws.1. Face/edge parallel