Makita 3601B Instruction Manual

Also see for 3601B: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

7MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.Replacing carbon brushes1001145Remove and check the carbon brushes regularly.Replace when they wear down to the limit mark. Keepthe carbon brushes clean and free to slip in the holders.Both carbon brushes should be replaced at the sametime. Use only identical carbon brushes.Use a screwdriver to remove the rear cover.12005049Use a screwdriver to remove the brush holder caps.Take out the worn carbon brushes, insert the new onesand secure the brush holder caps.Then install the rear cover with the screws.12005050CAUTION:• Do not turn the tool on without the rear coverinstalled in place.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers,always using Makita replacement parts.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized or Factory ServiceCenters, always using Makita replacement parts.ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Straight & groove forming bits• Edge forming bits• Laminate trimming bits• Straight guide• Trimmer guide• Templet guide 25• Templet guides• Templet guide adapter• Lock nut• Collet sleeve 3/8", 1/4"• Wrench 21• Wrench 23• Router stand1. Brush holdercap2. Screwdriver1. Screwdriver2. Rear cover1. Limit mark