Makita 3601B Instruction Manual

Also see for 3601B: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

4wobbling that could indicate improperlyinstalled bit.11. Be careful of the bit rotating direction and thefeed direction.12. Do not leave the tool running. Operate the toolonly when hand-held.13. Always switch off and wait for the bit to cometo a complete stop before removing the toolfrom workpiece.14. Do not touch the bit immediately afteroperation; it may be extremely hot and couldburn your skin.15. Do not smear the tool base carelessly withthinner, gasoline, oil or the like. They maycause cracks in the tool base.16. Use bits of the correct shank diameter suitablefor the speed of the tool.17. Some material contains chemicals which maybe toxic. Take caution to prevent dustinhalation and skin contact. Follow materialsupplier safety data.18. Always use the correct dust mask/respiratorfor the material and application you areworking with.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury. USD201-2SymbolsThe followings show the symbols used for tool.읭 volts읭 amperes읭 hertz읭 alternating current읭 no load speed읭 Class II Construction읭 revolutions or reciprocation per minuteFUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting the depth of cut12005039Place the tool on a flat surface. Turn the scale ring until itmakes contact with the base. Loosen the knob. Turn thescale ring until the bit just touches the flat surface.Tighten the knob. Place the tool on its side and turn thescale ring counterclockwise (when viewing the tool fromthe top) until the desired depth of cut is obtained. Onefull turn of the scale ring is equal to 5 mm (about 3/16")change in depth setting. Loosen the knob and move thetool base until it makes contact with the scale ring. Thentighten the knob securely.CAUTION:• Since excessive cutting may cause overload of themotor or difficulty in controlling the tool, the depthof cut should not be more than 15 mm (5/8") at apass when cutting grooves. When you wish to cutgrooves more than 15 mm (5/8") deep, makeseveral passes with progressively deeper bitsettings.Switch action12005040CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.1. Lock button2. Switch trigger1. Scale ring2. Knob