Makita 3620 Instruction Manual

Also see for 3620: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

8Straight guideThe straight guide is effectively used for straight cuts when chamfering orgrooving.To install the straight guide, insert the guide bars into the holes in the toolbase. Adjust the distance between the bit and the straight guide. At the desireddistance, tighten the wing bolts to secure the straight guide in place.When cutting, move the tool with the straight guide flush with the side of theworkpiece.If the distance (A) between the side of the workpiece and the cutting position istoo wide for the straight guide, or if the side of the workpiece is not straight, thestraight guide cannot be used. In this case, firmly clamp a straight board to theworkpiece and use it as a guide against the router base. Feed the tool in thedirection of the arrow.Templet guide (Accessory)The templet guide provides a sleeve through which the bit passes, allowinguse of the tool with templet patterns.To install the templet guide, loosen the screws on the tool base, insert the tem-plet guide and then tighten the screws.0032591. Straight guide2. Guide bar3. Wing bolt12 3003260A0032610032621. Screw2. Base plate3. Templet guide1 23003263

/ 12

Related manuals for Makita 3620

Makita 3620 Instruction Manual

Makita 3606 Instruction Manual

This manual is suitable for:

3620

manualsdatabase

Your AI-powered manual search engine